Skating Boots to ICE BLADES (TEMP Mount and Including Drill Bit Extension)
Temp Mounting of the 4 Slots and providing the 2.0mm (5/64″) drill Bit Extension   which provides the Skater with the ability to make the final Blade position adjustments and then use the Drill Bit Extension to drill the pilot holes for installing ALL of the Countersunk EDEA Hi-Lo thread countersunk Screws to finish the mount.
SkatesUS.com is the best source for mounting high end Skating Boots and Ice Blades. SkatesUS.com will mount just about any Skating Boot to any Ice Blade with the same care and concern. At SkatesUS.com , we take our time to Mount and strive to be extremely accurate.
Blade Alignment and Mounting should be very consistent and accurate. With the newer designs of Skating Boots and Blades, we believe that our current methods reflect the best Alignment and Mounting methods, which are also used by some of the very best technicians mounting ICE Skates. Our methods and procedures are proper for today’s equipment. Sometimes Professional Mounting is as much an Art as it is a Science.
When Mounting to EDEA Skates , Blade Sizing is very consistent for each size and between models, please use the Sizing Chart available at the Learning Center on SkatesUS.com. When Mounting EDEA Skates , SkatesUS.com mounts using the special EDEA Screws which have a combination High-Low Thread system (one bites and one grips) and we supply the additional screws that are needed to complete the mount. Pilot holes must be drilled completely through the sole of the Boot and the bottom level of the heel to the void in the heel, so that the screws can seat properly. Once the Blade is aligned the mount is completed, no additional water proofing of the Skates should be necessary. .
SkatesUS.com mountings are backed by a thorough personal knowledge and understanding Skating ourselves, and just how important a Professional Mount is to allow a Skater to perform at their BEST.
Pricing is for Labor and only includes the Drill Bit Extension, but Does NOT include Shipping Costs.